Datalink Kit A/B/C - Veronte SDL Modem

1. First of all, to access the expansion bay, read Expansion bay access section of this manual. It will not be necessary to take out the bay plate.

2. Screw the modem to the plate with four mushroom bolts M3 x 4.

   

   Hardware SDL installation - Step 2

3. Wire the modem to the bay connector and RF2.

   

   Hardware SDL installation - Step 3

4. Mount the PCS to the pole according to Pole mount installation section of this manual (do not close the expansion bay yet).

5. Attach the omnidirectional antenna to the pole mount.

   

   Hardware SDL installation - Step 5

6. Wire the antennas to the PCS.

   

   Hardware SDL installation - Step 6

   (Diagram not scaled)

7. Configure the Veronte Autopilot 1x as explained in External radios - Integration examples section of 1x PDI Builder user manual.

8. Configure the Veronte Autopilot 1x to communicate with SDL through a tunnel, to do it read Tunnel - Input/Output section of 1x PDI Builder user manual.

9. Once the tunnel communication is established through Autopilot 1x, the modem can be configured with AT commands.

   9.1. To understand the basics, first of all, read How to configure SDL - Software Installation section of SDL User Manual.

   9.2. After that, read Veronte Autopilot 1x and Veronte BCS - Integration Examples section of SDL User Manual, to configure the SDL according to the autopilot used.

10. Once the SDL and the Autopilot 1x have been configured, close the PCS.